Effect of tubular-typed charcoal height variations on efficiency in passive interfacial solar desalination

Tri Ramadhani Pardiono, Muhamad Jafri, Ben Vasco Tarigan

Abstract


Passive solar desalination is a process of reducing the salt content of salt water to produce fresh water by utilizing solar heat. In recent years, interfacial heating has been proposed as an alternative to evaporation by creating localized heat on the water surface. Charcoal is an absorbent, heat storage, and wettability material, so the evaporation process not only occurs on the surface of seawater but also on the surface of the charcoal, which results from this wettability. The height of the charcoal indicates the distance the steam travels to reach the glass surface for the condensation process, thereby speeding up evaporation. The experiment was carried out in 4 single-slope-type basins using tubes filled with charcoal as high as 30, 40, and 50 mm for 8 hours in the sun. The results showed that adding heat-absorbing material to the basin was able to accelerate seawater to reach its boiling point so that it could evaporate. The temperature and humidity in each basin also have a similar changing trend where temperature is strongly influenced by solar radiation. The use of charcoal can also increase the rate of convection and evaporation heat transfer in the basin, as well as the maximum efficiency in basin 4 with an efficiency value of 56.40%, basin 2 at 53.17%, basin 3 at 51.62%, and basin 1 44.17%. Efficiency is obtained from the desalination efficiency equation, namely the ratio of the latent heat of vaporization to the solar energy entering the system

Keywords


Solar desalination, distillation, solar still, interfacial evaporation, charcoal

Full Text:

PDF

References


A. JafarGholiBeik, M. R. Assari, and H. BasiratTabrizi, “Passive and active performance of a multi-side-stepped square pyramid solar still; experimental and modeling,” J Energy Storage, vol. 32, Dec. 2020, doi: 10.1016/j.est.2020.101832.

S. Loutatidou, M. O. Mavukkandy, S. Chakraborty, and H. A. Arafat, “Introduction: What is Sustainable Desalination?,” in Desalination Sustainability: A Technical, Socioeconomic, and Environmental Approach, Elsevier Inc., 2017, pp. 1–30. doi: 10.1016/B978-0-12-809791-5.00001-8.

A. Pugsley, A. Zacharopoulos, J. D. Mondol, and M. Smyth, “Solar Desalination Potential Around the World,” in Renewable Energy Powered Desalination Handbook: Application and Thermodynamics, Elsevier Inc., 2018, pp. 47–90. doi: 10.1016/B978-0-12-815244-7.00002-7.

F. Tao, A. Valenzuela Garcia, T. Xiao, Y. Zhang, Y. Yin, and X. Chen, “Interfacial Solar Vapor Generation: Introducing Students to Experimental Procedures and Analysis for Efficiently Harvesting Energy and Generating Vapor at the Air-Water Interface,” J ChemEduc, vol. 97, no. 4, pp. 1093–1100, Apr. 2020, doi: 10.1021/acs.jchemed.9b00643.

M. M. Naima, M. A. Abd, and E. Kawib, “Non-conventional solar stills Part 1.Non-conventional solar stills with charcoal particles as absorber medium,” Desalination, vol. 153, pp. 55–64, 2002, [Online]. Available: www.elsevier.com/locate/desal

T. Elango, A. Kannan, and K. KalidasaMurugavel, “Performance study on single basin single slope solar still with different water nanofluids,” Desalination, vol. 360, pp. 45–51, Mar. 2015, doi: 10.1016/j.desal.2015.01.004.

A. Sadoun, A. Khechekhouche, I. Kemerchou, M. Ghodbane, and B. Souyei, “Impact of natural charcoal blocks on the solar still output,” Heritage and Sustainable Development, vol. 4, no. 1, pp. 61–66, Apr. 2022, doi: 10.37868/hsd.v4i1.80.

M. Jafri, B. V. Tarigan, and D. G. H. Adoe, “Solar desalination with charcoal briquettes from plants as an additional absorption sorbent,” Heritage and Sustainable Development, vol. 6, no. 1, pp. 183–196, Mar. 2024, doi: 10.37868/hsd.v6i1.306.

B. V. Tarigan, M. Jafri, and D. G. H. Adoe, “Use of coconut shell charcoal briquettes as PCM seawater distillation,” 2024, p. 060005. doi: 10.1063/5.0210341.

V. K. Sonker, J. P. Chakraborty, A. Sarkar, and R. K. Singh, “Solar distillation using three different phase change materials stored in a copper cylinder,” Energy Reports, vol. 5, pp. 1532–1542, Nov. 2019, doi: 10.1016/j.egyr.2019.10.023.

H. M. Wilson, Tushar, S. RahemanAr, and N. Jha, “Plant-derived carbon nanospheres for high efficiency solar-driven steam generation and seawater desalination at low solar intensities,” Solar Energy Materials and Solar Cells, vol. 210, Jun. 2020, doi: 10.1016/j.solmat.2020.110489.

J. Roslan, W. E. Kan, A. K. Abdul Rahman, M. Suliman, and R. Isha, “Charcoal characterization and application is solar evaporator for seawater desalination,” in IOP Conference Series: Materials Science and Engineering, Institute of Physics Publishing, Mar. 2020. doi: 10.1088/1757-899X/736/2/022107.

A. Khechekhouche, B. Benhaoua, M. Manokar, R. Sathyamurthy, A. E. Kabeel, and Z. Driss, “Sand dunes effect on the productivity of a single slope solar distiller,” Heat and Mass Transfer/Waerme- und Stoffuebertragung, vol. 56, no. 4, pp. 1117–1126, Apr. 2020, doi: 10.1007/s00231-019-02786-9.

V. Belessiotis, S. Kalogirou, and E. Delyannis, Thermal Solar Desalination. Chennai, India: Academic Press, 2016.

V. B. Sharma and S. C. Mullick, “Estimation of Heat-Transfer Coefficients, the Upward Heat Flow, and Evaporation in a Solar Still,” J Sol Energy Eng, vol. 113, pp. 36–41, 1991, [Online]. Available: http://solarenergyengineering.asmedigitalcollection.asme.org/

G. N. Tiwari and R. Tripathi, “Study of heat and mass transfer in indoor conditions for distillation,” Desalination, vol. 154, pp. 161–169, 2003, [Online]. Available: www.elsevier.com/locate/desal

A. S. Abdullah, F. A. Essa, H. Ben Bacha, and Z. M. Omara, “Improving the trays solar still performance using reflectors and phase change material with nanoparticles,” J Energy Storage, vol. 31, Oct. 2020, doi: 10.1016/j.est.2020.101744.

H. Zheng, Solar Energy Desalination Technology. Beijing: Elsevier, 2017.




DOI: http://dx.doi.org/10.30811/jpl.v22i3.4890

Refbacks

  • There are currently no refbacks.




Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

 

  

    

    

Lisensi Creative Commons

Ciptaan disebarluaskan di bawah Lisensi Creative Commons Atribusi-BerbagiSerupa 4.0 Internasional.

 

Mailing Address:

Politeknik Negeri Lhokseumawe

Jl. Banda Aceh-Medan
Km. 280,3, Buketrata, Mesjid Punteut, Blang Mangat,
Kota Lhokseumawe, 24301

Propinsi Aceh,
Indonesia